How to Get to PhilHealth Main Office (Pasig) via Expressway

The nearest expressway exit to PhilHealth Main Office (Pasig) is Bicutan on the SLEX. From this exit, PhilHealth Main Office (Pasig) is approximately 20-25 min via C-5.

The toll fee from Balintawak (NLEX) to the nearest exit (Bicutan) is ₱336 for Class 1 vehicles. Toll fees vary depending on your starting point and vehicle class. All rates shown are VAT-inclusive and based on 2026 TRB-approved toll rates.

The SLEX uses the Autosweep RFID system. Ensure your Autosweep RFID has sufficient balance before your trip.

Travel time to PhilHealth Main Office (Pasig) depends on your starting point and traffic conditions. Using expressways is typically the fastest option. From the Bicutan exit, PhilHealth Main Office (Pasig) is 20-25 min via C-5. Peak hours (7-9 AM and 5-8 PM on weekdays) may add 30-60 minutes to your trip.

Yes, you can use Waze or Google Maps for turn-by-turn navigation to PhilHealth Main Office (Pasig). We recommend selecting the "highways" or "expressway" option in your navigation app to ensure you take the toll road route via SLEX. Check toll fees here before you go so you know how much RFID balance you'll need.

The estimated fuel cost to reach PhilHealth Main Office (Pasig) is ₱70–95 for a sedan/small SUV. The route covers approximately 13 km total (8 km expressway + 5 km local roads). Your total trip cost including toll fees is approximately ₱431. Based on gasoline at ₱62.5/L and 7.5 L/100km expressway consumption.

The estimated drive time to PhilHealth Main Office (Pasig) is approximately 19 min via expressway under normal traffic. During rush hour (7-9 AM, 5-8 PM weekdays), add 30-60 minutes. Weekend mornings are typically the best time to travel for minimal traffic on the expressways.

No. All Philippine expressways now require RFID for cashless toll collection. Cash lanes have been discontinued. Install an Autosweep or Easytrip RFID sticker (free at toll plazas) and load sufficient balance before your trip. Check which RFID system you need in the RFID Requirements section above.