How to Get to Alabang Town Center (ATC) via Expressway

The nearest expressway exit to Alabang Town Center (ATC) is Alabang on the SLEX. From this exit, Alabang Town Center (ATC) is approximately 5 min from exit. An alternative exit is Filinvest on the SLEX.

The toll fee from Balintawak (NLEX) to the nearest exit (Alabang) is ₱428 for Class 1 vehicles. Toll fees vary depending on your starting point and vehicle class. All rates shown are VAT-inclusive and based on 2026 TRB-approved toll rates.

The SLEX uses the Autosweep RFID system. Ensure your Autosweep RFID has sufficient balance before your trip.

Travel time to Alabang Town Center (ATC) depends on your starting point and traffic conditions. Using expressways is typically the fastest option. From the Alabang exit, Alabang Town Center (ATC) is 5 min from exit. Peak hours (7-9 AM and 5-8 PM on weekdays) may add 30-60 minutes to your trip.

Yes, you can use Waze or Google Maps for turn-by-turn navigation to Alabang Town Center (ATC). We recommend selecting the "highways" or "expressway" option in your navigation app to ensure you take the toll road route via SLEX. Check toll fees here before you go so you know how much RFID balance you'll need.

The estimated fuel cost to reach Alabang Town Center (ATC) is ₱108–146 for a sedan/small SUV. The route covers approximately 21 km total (16 km expressway + 5 km local roads). Your total trip cost including toll fees is approximately ₱574. Based on gasoline at ₱62.5/L and 7.5 L/100km expressway consumption.

The estimated drive time to Alabang Town Center (ATC) is approximately 25 min via expressway under normal traffic. During rush hour (7-9 AM, 5-8 PM weekdays), add 30-60 minutes. Weekend mornings are typically the best time to travel for minimal traffic on the expressways.

No. All Philippine expressways now require RFID for cashless toll collection. Cash lanes have been discontinued. Install an Autosweep or Easytrip RFID sticker (free at toll plazas) and load sufficient balance before your trip. Check which RFID system you need in the RFID Requirements section above.