How to Get to Tarlac State University (TSU) via Expressway

The nearest expressway exit to Tarlac State University (TSU) is Tarlac on the SCTEX. From this exit, Tarlac State University (TSU) is approximately 10-15 min from exit.

The toll fee from Balintawak (NLEX) to the nearest exit (Tarlac) is ₱670 for Class 1 vehicles. Toll fees vary depending on your starting point and vehicle class. All rates shown are VAT-inclusive and based on 2026 TRB-approved toll rates.

The SCTEX uses the Easytrip RFID system. Ensure your Easytrip RFID has sufficient balance before your trip.

Travel time to Tarlac State University (TSU) depends on your starting point and traffic conditions. Using expressways is typically the fastest option. From the Tarlac exit, Tarlac State University (TSU) is 10-15 min from exit. Peak hours (7-9 AM and 5-8 PM on weekdays) may add 30-60 minutes to your trip.

Yes, you can use Waze or Google Maps for turn-by-turn navigation to Tarlac State University (TSU). We recommend selecting the "highways" or "expressway" option in your navigation app to ensure you take the toll road route via SCTEX. Check toll fees here before you go so you know how much RFID balance you'll need.

The estimated fuel cost to reach Tarlac State University (TSU) is ₱572–774 for a sedan/small SUV. The route covers approximately 120 km total (115 km expressway + 5 km local roads). Your total trip cost including toll fees is approximately ₱1,444. Based on gasoline at ₱62.5/L and 7.5 L/100km expressway consumption.

The estimated drive time to Tarlac State University (TSU) is approximately 1h 44m via expressway under normal traffic. During rush hour (7-9 AM, 5-8 PM weekdays), add 30-60 minutes. Weekend mornings are typically the best time to travel for minimal traffic on the expressways.

No. All Philippine expressways now require RFID for cashless toll collection. Cash lanes have been discontinued. Install an Autosweep or Easytrip RFID sticker (free at toll plazas) and load sufficient balance before your trip. Check which RFID system you need in the RFID Requirements section above.