SLEX RFID 2026: Autosweep Installation, Balance and Reload
SLEX uses the Autosweep RFID system operated by SMC Tollways. Bring the vehicle and required documents to an authorized site. Ask the site to separate any installation or replacement charge from the prepaid toll load before you pay.
By Aditya AmanPublished Feb 7, 2026Editorial PolicyLives in the Philippines and has driven nearly every Luzon expressway with his family.Quick Facts
Autosweep
SMC Tollways
Confirm with site
Confirm for vehicle class
Service charge + credited load
8
SLEX RFID Installation Sites
8 Autosweep installation sites along SLEX. 4 sites are open 24/7. All sites accept walk-in customers.
Autosweep SLEX Southwoods
Biñan, Laguna
NB lane is 24/7; SB lane closes at 6 PM
Autosweep SLEX Calamba
Calamba, Laguna
Autosweep SLEX Santa Rosa
Santa Rosa, Laguna
Autosweep SLEX Ayala Greenfield
Santa Rosa, Laguna
Autosweep SLEX Sucat/Parañaque
Parañaque, Metro Manila
Near Soldier Hills Skyway Extension area
Autosweep SLEX Alabang
Muntinlupa, Metro Manila
Autosweep SLEX Mamplasan
Biñan, Laguna
Autosweep SM Southmall
Las Piñas, Metro Manila
Located at ground floor parking area
SLEX RFID Cost Breakdown
| Item | Cost |
|---|---|
RFID Sticker | Confirm with site |
Initial Load (credited as toll balance) | Confirm for vehicle class |
| Total | Service charge + credited load |
How to Reload SLEX RFID
Reload your Autosweep RFID balance using any of these methods:
How to Check SLEX RFID Balance
Check your Autosweep RFID balance before entering the expressway:
SLEX RFID Installation: Step-by-Step
- 1
Gather Your Documents
Bring your vehicle OR/CR (original or photocopy), a valid government ID, and cash for the initial load.
- 2
Visit a Autosweep Installation Site
Go to any SLEX Autosweep installation site listed above. All sites accept walk-ins, no appointment needed.
- 3
Present Your Documents & Pay
Hand over your OR/CR and ID to the attendant. Ask the site to separate the current installation or replacement charge from the amount credited as prepaid toll load.
- 4
RFID Sticker Installation
The attendant will clean the designated area of your windshield and install the RFID sticker. This typically takes 5-10 minutes.
- 5
Verification & Activation
Your RFID will be tested and activated on the spot. You will receive a receipt with your account number. Save this for balance checks and reloads.
SLEX Toll Rates 2026
View the complete toll fee matrix for SLEX. Calculate exact fees for Class 1, 2, and 3 vehicles.
View Toll MatrixSLEX RFID by the Numbers
- 8
- RFID installation sites along SLEXSource: Expressway.PH Database
- 4
- sites open 24/7Source: Autosweep Official
- 2
- provinces covered (Laguna, Metro Manila)Source: Expressway.PH Database
- Confirm
- current service charge and initial load before visitingSource: Autosweep Terms and Authorized Sites
RFID Sites by Province
View all RFID installation sites in each province served by SLEX.
Useful SLEX Links
Other Expressway RFID Guides
Frequently Asked Questions
What RFID is used in SLEX?
SLEX takes Autosweep. An Easytrip sticker will not open its lanes; you need an Autosweep account, which also covers SLEX, Skyway, NAIAX, STAR and MCX. Installation sites, balance checks and reload options are below.
Can I use Easytrip RFID on SLEX?
Yes, once your Easytrip sticker is enrolled in One RFID. Easytrip's FAQ lists SLEX among the SMC roads an enrolled Easytrip RFID pays on, from the same load balance. Without enrollment, SLEX reads Autosweep only.
Where are the 24/7 Autosweep installation sites on SLEX?
Use the installation-site list on this page and confirm hours with Autosweep before leaving. Service hours can differ by direction and by task, so a 24-hour toll plaza does not always mean every RFID service is available around the clock.
How much does Autosweep RFID cost for SLEX?
Confirm the current amount for your specific installation or replacement at the authorized site. Ask the staff to show which amount is a service charge and which amount becomes prepaid toll credit. Do not rely on an old fixed-price package quoted by an unofficial guide.
What are the requirements for SLEX RFID?
Bring the vehicle, its OR/CR, a valid government ID, and any ownership or authorization document relevant to the application. Bring funds for the current service charge and initial load after confirming both with the site. The installer must assess and position the tag on the actual vehicle.